Description:

 

• New, Previous, Next

When selecting these options, a dialog box in which you have the option of editing the highlighted line will appear.

 

• Text Old, Text New

This interface is shown on the side panel. At the top left of the interface is a field that contains the previously used special character definition or the text which is to be replaced (text Old). Top right (Text New) is the associated substitute special character or the corresponding replacement text. These two fields can be selected with the mouse or the TAB key to change them. The syntax fields (any character string etc. are explained in the next chapter)

 

• Analysis Result

If the DWG or DXF file was previously analyzed (see chapter Analysis), selecting one of the analysis buttons will make a list of characters, and texts.

• Suggestions

By selecting the lists, you can display a standard list of the ASCII, or UNICODE character definitions, or %% sequences used in CAD.

 

• Text Context (from the analysis)

After selecting a special character from the analysis, under the heading “Text Context”, a maximum of five different text passages are displayed in which the character is used. It is often the only way to determine the meaning of a special character. For example, when translating from English “WALL” into the Spanish word “PARED”, “Word” must be selected (or it must be written under the selection “Word”). This will ensure that only full words are transformed.

 

Select from the following options under “Old Text”:

• Any String
• ASCII code
• Unicode
• Beginning of word
• End of word
• Word
• Texts with this string

 

Select from the following option under “New Text”:

• Any String
• ASCII code
• Unicode
• Delete string

 

For example, if a company need be deleted from the drawing, set “Old Text” to “Any String” and the “New String” to “Delete String” to delete it completely.