Print2CAD 2019, Artificial Intelligence
Analysis before Calibration of Coordinates
The calibration of the coordinates allows the user to correct the inaccurate coordinates by means of calibration points.
Start the Print2CAD analysis and look at the separated PDF images.
The calibration points can be defined in the paths or in the raster images. Find in the separated images the ends of the polylines. These can be defined as calibration points. The points of the raster traces after the vectorization can serve as calibration points. You can also define the calibration points freely in the drawing, without a connection to an existing point.
Try to find the information about the nominal coordinates of the points in the analysis images.
BacktoCAD Technologies, LLC
601 Cleveland St, Suite 310
Clearwater, FL 33755, USA
Phone: (727) 303 0383
© Copyright 2017 BackToCAD Technologies, LLC. All rights reserved. Kazmierczak® is a registered trademark of Kazmierczak Software GmbH. Print2CAD, AzubiCAD, and CAD2Print are Trademarks of BackToCAD Technologies LLC. CADconv is a Trademark of Expert Robotics Inc.. DWG is the name of Autodesk’s proprietary file format and technology used in AutoCAD® software and related products. Autodesk, the Autodesk logo, AutoCAD, DWG are registered trademarks or trademarks of Autodesk, Inc., and/or its subsidiaries and/or affiliates in the USA and/or other countries. All other brand names, product names, or trademarks belong to their respective holders. This website is independent of Autodesk, Inc., and is not authorized by, endorsed by, sponsored by, affiliated with, or otherwise approved by Autodesk, Inc. The material and software have been placed on this Internet site under the authority of the copyright owner for the sole purpose of viewing of the materials by users of this site. Users, press or journalists are not authorized to reproduce any of the materials in any form or by any means, electronic or mechanical, including data storage and retrieval systems, recording, printing or photocopying.